How many feet a minute? View answer
Asked 4 ´years ago | Thern Liberty Capstan Winch
Would it be possible to order one spliced with a snap on each end, other than the single klimair two in one flip that is offered. Wondering the pricing to have you guys just splice a 12 foot wire core with two snaps, assuming I already had a klimair and that it could be taken off a worn flip and put on a new one. View answer
Asked 3 ´years ago
Why is this item so much less expensive than most of your other shackles for the same WLL? I plan to use two of these to connect trailer safety chains to my Ford F250 pickup truck. The trailer I am towing is rated at 7,000 lbs. Are these suitable for that application? View answer
Asked 6 ´years ago | 5/8" Bolt Type Anchor Shackle - 3-1/4 Ton WLL
Can I order this padlock with more keys? View answer
Asked 7 ´years ago | Peerless Security Chain Padlock
Is this made in the USA? View answer
Asked 3 ´years ago | Durabilt 6" Snatch Block w/ Hook - 8 Ton WLL
Is it an issue to run 1/4" or 7/16" cord? View answer
Asked 7 ´years ago
Do you have 12 of these in stock? View answer
Asked 6 ´years ago
How wide is the hoe part of the head? View answer
Asked 5 ´years ago
Do u have anything bigger than this ? View answer
Asked 4 ´years ago | Ergodyne 5743 Plastic-Bottom Hoist Bucket
Where do you grease these blocks? View answer
Asked 3 ´years ago | Young 1569 Half Side Haulback Block - 15 Ton WLL
Do you have them in 1/4" x 1-1/4"? View answer
Asked 7 ´years ago | SpeeCo 1/4" x 1-1/2" Ball Detent Pin
How much weight does it hold? View answer
Asked 6 ´years ago | Weaver WLC-330 Floating D Arborist Saddle
Hello, I have a Hayate saw and found this FOXADP adapter on a site in the UK. http://www.silkyfox.co.uk/accessories.phpAdaptor for Sintung 50 - This adaptor converts the fitting on a Sintung 50 lopper to allow for connection to a Hayate pole saw.Do you have access to these?Thank you, Jim View answer
Asked 6 ´years ago
What is the load capacity of this rope? View answer
Asked 5 ´years ago | PCC 3/8" Solid Core Rubber Rope
What is the minimum load requirement for this clamp? I would be using this clamp to habitually lift 3/8" thick steel plate that weighs between 375 and 400 lbs in a 36" x 98" sheet. Since it is advisable for safety and longevity of the clamp to lift as close to the max capacity as possible, if this clamp will not work, do you have another model # that will? View answer
Asked 4 ´years ago | AMH 1 Ton Vertical Plate Lifting Clamp - #PCUA010
What is the height? View answer
Asked 7 ´years ago