Do you do a 240V AC version of this? View answer
Asked 7 ´years ago
Does the Lock-N-Lift lifting tool work on these plates? View answer
Asked 2 ´years ago | ADB Fast-Lok Weld-on Plate
I have a concern with a crane on our project using a wedge socket upside down. I have never seen someone use it in this manner. I was checking to see if this was an ok practice or if it was against manufacturers recommendations. There are two systems on this crane, one right side up and the other upside down. Any advice or knowledge on this matter is appreciated.Glen View answer
Asked 7 ´years ago | Crosby 5/8" S-421T Terminator Wedge Socket - #1035018
I have a concern with a crane on our project using a wedge socket upside down. I have never seen someone use it in this manner. I was checking to see if this was an ok practice or if it was against manufacturers recommendations. There are two systems on this crane, one right side up and the other upside down. Any advice or knowledge on this matter is appreciated.Glen View answer
Asked 7 ´years ago | Crosby 5/8" S-421T Terminator Wedge Socket - #1035018
Has anyone used this for a boat lift application? View answer
Asked 6 ´years ago
I bought from you a (Laclede -security-chain-012) for a lock EuroMonomilth that I have,, Now the chain doesnt fit in the lock...Do this chai is going to fit in a ViroEuroMonolith?.as you see in the picture the shackles just try to fit but it doesnt go through and if I apply force then it wont lock. View answer
Asked 8 ´years ago | Pewag 1/2" (12mm) Galvanized Square Security Chain
Do these clamps automatically release when the weight of the load is removed, i.e. a sheet is set on a surface in the vertical position? Does the red lever lock the clamp in place after the load is applied to the chain? View answer
Asked 4 ´years ago | Terrier 0.5 TNMK Non-Marring Lifting Clamp - #862035
Are these in stock? View answer
Asked 6 ´years ago
How much load can it withstand? View answer
Asked 7 ´years ago
